Magnum V6-3.5L VIN V (2006)
Headlamp Washer Pump: Service and Repair
HEADLAMP WASHER PUMP MOTOR
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the
front (outboard) washer pump and allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front
washer pump.
3. Remove the washer reservoir.
4. Disconnect the high pressure headlamp washer pump hose by pressing down firmly on latch and pulling hose off.
5. Disconnect the high pressure headlamp washer pump motor electrical connector (1).
6. Remove pump from reservoir by pulling pump up and away from reservoir cavity and out of mounting grommet. Do not damage reservoir/pump
sealing surface or puncture reservoir during removal.
7. Remove pump grommet and discard.
INSTALLATION
1. Use new grommet when installing a new pump assembly.
2. Assure that the pump is aligned to and fully seated in the reservoir cavity.
3. Install the washer reservoir.
4. Connect the electrical harness connectors to the washer pump motors and the fluid level sensor.
5. Connect the high pressure headlamp washer hose by firmly pushing hose onto inlet until a snap is heard.
6. Refill the reservoir with fluid drained previously.
7. Connect the battery negative cable.
