Magnum V8-5.7L (2008)
64. Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.). See: Maintenance/Wheels and Tires/Service and
Repair/Removal and Replacement/Tires and Wheels - Installation
65. Lower vehicle.
66. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
67. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
68. Perform wheel alignment, paying special attention to thrust angle. If rear crossmember needs to be shifted to align thrust angle, try to avoid
compromising tension link clearance (Refer to STEP 33). See: Maintenance/Alignment/Service and Repair
69. On each side of crossmember, while holding cam bolt from turning, tighten toe link cam bolt nut (2) to 108 Nm (80 ft. lbs.) torque.