Magnum V8-5.7L (2008)
29. Match left rear wheel speed sensor connector (4) to right sensor connector (3) to make one connector.
30. Insert speed sensor connectors (3 and 4) into body wiring harness connector (1) located in luggage compartment floor pan (2). When installing
connector, make sure retaining clip on body connector is properly in place and sensor connector cannot be pulled out.
31. If equipped with standard or premium disc brakes, on each rear disc brake:
a. Push caliper guide pins into caliper adapter to clear caliper mounting bosses when installing.
b. Guide caliper and brake hose down through rear suspension, then slide caliper over brake pads and onto caliper adapter (3).
c.
CAUTION: Extreme caution should be taken not to cross-thread caliper guide pin bolts (2) when they are installed.
Align caliper mounting holes with guide pins, then install guide pin bolts (2). While holding guide pins from turning, tighten bolts to 31 Nm (23 ft. lbs.)
torque.
d. Make sure brake hose is properly routed and will not come in contact with suspension components.
32. If equipped with SRT8 disc brakes, at each rear disc brake, support spring link using a transmission jack or other appropriate jack as indicated in
removal procedure.
