Magnum V8-5.7L (2008)
6. Install the seat assembly See: Service and Repair/Seat - Installation.
7. Connect the battery negative cable.
8. Verify normal operation of the power seat assembly.
HEIGHT ADJUST MOTOR
1. Ensure the seat adjuster (2) is in the full up position by pulling upward on the upper adjuster assembly.
2. Position motor (3) on seat adjuster (2).
3. Install the motor shaft screw and washer and tighten until snug. Do not torque screw at this time.
4. Install the screws (1) holding the motor (3) to the seat adjuster (2). It may be necessary to twist the motor slightly to align the fastener holes.
5. Starting with the bottom screw, tighten the motor screws (1) to 9 Nm (80 in. lbs.).
6. Tighten the motor shaft screw and washer to 6.5 Nm (57.5 in. lbs.).
7. Connect the motor electrical connector.
8. Install the seat cushion See: Seat Cushion/Service and Repair/Seat Cushion / Cover - Installation.
9. Clip the wire harness to cushion pan.
