Magnum V8-5.7L (2008)
Brake Pedal Assy: Service and Repair
Installation
PEDAL
1. Install adjustable brake pedal assembly (4) under instrument panel and slide over booster push rod.
2. From engine compartment side, push power brake booster (3) mounting studs back through dash panel (2) and brake pedal bracket.
3. Install two upper mounting nuts (1) fastening pedal bracket to upper dash panel (2). Do not tighten at this time.
4. Install four power brake booster mounting nuts (1). Tighten nuts to 25 Nm (18 ft. lbs.) torque.
5. Tighten two upper mounting nuts (1) to 25 Nm (18 ft. lbs.) torque.
6. Slide booster push rod (5) onto brake pedal pin (4). Install NEW retaining clip (3) securing push rod to brake pedal.
7. Install and adjust brake lamp switch (2). See: Lighting and Horns/Brake Light Switch/Service and Repair/Installation
8. Install steering column opening cover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Steering
Column Opening Cover - Installation
9. Install driver side silencer under instrument panel.See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Silencer Panel - Installation
