Magnum V8-5.7L (2008)
NOTE: SRT8 vehicles have the minimum thickness specification stamped into the outer diameter edge (1) (along vented end) of the disc.
Before lathe installation, verify the brake rotor face and the hub adapters are free of any chips, rust, or contamination.
When mounting and using the brake lathe, strict attention to the brake lathe manufacturer's operating instructions is required.
Machine both sides of the brake rotor at the same time. Cutting both sides at the same time minimizes the possibility of a tapered or uneven cut.
When refacing a rotor, the required TIR (Total Indicator Reading) and thickness variation limits MUST BE MAINTAINED. Extreme care in the
operation of rotor turning equipment is required. Specifications for brake rotor machining can be found in this sections specification table. See:
Specifications
