Magnum V8-5.7L (2008)
5. If original parking brake lever is being installed:
a. Connect front parking brake cable strand (1) to cable connector (2) secured in retaining fork.
b. Once front parking brake cable strand is completely seated in cable connector (2), lift cable connector out of retaining fork using pliers and
slowly allow lever mechanism to take up slack in cable.
6. If NEW parking brake lever is being installed:
a. Connect front parking brake cable strand (3) at lever connector (2).
b. Once front parking brake cable strand is completely seated in cable connector (2), remove pin locking out automatic tensioning spring.
7. Install steering column opening cover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Steering
Column Opening Cover - Installation
8. Raise and support vehicle.
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
9. Connect front parking brake cable (5) at connector (3) to right rear parking brake cable (4).
10. Lower vehicle until rear wheels are just above floor level.
11. Apply parking brake lever. Release lever to test release cable and handle. Reapply lever. While doing this, check to make sure the red indicator
lamp in the cluster turns on and off properly.
