Magnum V8-5.7L (2008)
3. Slide booster push rod (5) onto brake pedal pin (4). Install NEW retaining clip (3) securing push rod to brake pedal.
4. Install and adjust brake lamp switch (2). See: Lighting and Horns/Brake Light Switch/Service and Repair/Installation
5. Connect vacuum hose (3) to check valve (2) on face of booster (1). Do not remove check valve from booster.
6. If equipped with MK25 and Electronic Stability Program (ESP), connect wiring harness (6) connector at pedal travel sensor (7) on power brake
booster (3).
7. If equipped with MK25 and ESP, connect wiring harness (6) connector at active brake booster solenoid (4).
8. Install master cylinder (1). See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and Replacement/Master Cylinder -
Installation
9. Install windshield wiper module and components removed to access. See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Wiper
Module - Installation
