Magnum V8-5.7L (2008)
WARNING: To service the speed control switch, the entire assembly that houses the speed control switch must be removed from the column.
This must be done due to the clockspring passing through the assembly and into the self docking connector. Failure to remove the this assembly
could damage the pins of the clockspring during installation and prevent the airbag system from operating properly.
4. Connect the electrical connector (2).
5. Install the SCCM assembly (1) onto the steering column.
6. Tighten the set screw (3) securing the SCCM assembly (1) to the steering column. Tighten screw to 4 Nm (35 in. lbs.).
7. Tighten the remaining clockspring T10 Torx screw to.7 Nm (6 in. lbs.).
8. Align the spline on the steering wheel hub to shaft and install the steering wheel (1).
9. Install a NEW retaining bolt (2). Tighten the bolt to 75 Nm (55 ft. lbs.).
