Magnum V8-5.7L (2008)
Crankshaft Seal Retainer: Service and Repair
Crankshaft Rear Oil Seal Retainer - Installation
INSTALLATION
1. Thoroughly clean all gasket residue from the engine block.
2. Use extreme care and clean all gasket residue from the retainer.
3. Position the gasket onto the retainer.
4. Position the retainer onto the engine block.
5. Install the retainer mounting bolts. Tighten the bolts to 15 Nm (132 in. lbs.) using the procedure shown.
6. Install the oil pan See: Engine Lubrication/Oil Pan/Service and Repair/Engine Oil Pan - Installation.
7. Install the flexplate See: Transmission and Drivetrain/Flex Plate/Service and Repair/Installation.
8. Install the transmission.
9. Check and verify engine oil level.
10. Start engine and check for leaks.
