Magnum V8-5.7L (2008)
10. Install the evaporator temperature sensor (2) See: Evaporator Temperature Sensor / Switch/Service and Repair/Installation.
11. Install the blower motor resistor or power module (3), depending on application See: Blower Motor Resistor/Service and Repair/Installation or
See: Control Module HVAC/Service and Repair/Blower Motor Power Module - Installation.
12. Install the blower motor (4) See: Blower Motor/Service and Repair/Installation.
13. Connect the HVAC wire harness (1) to the evaporator temperature sensor, blower motor resistor or power module (depending on application) and
the blower motor.
14. Install the two HVAC wire harness retainers (5) onto the blower motor.
15. Install the heater core tubes (4) and the flange (2) to the front of the HVAC housing (3).
16. Install the two screws (1) that secure the flange to the HVAC housing. Tighten the screws to 2.2 Nm (20 in. lbs.).
17. Install the air inlet housing (2) onto the HVAC housing (1) See: Removal and Replacement/HVAC Housing - Installation.
18. Install the air distribution housing (3) onto the HVAC housing See: Removal and Replacement/HVAC Housing - Installation.
19. Install the HVAC housing assembly See: Removal and Replacement/HVAC Housing - Installation.
