Magnum V8-5.7L (2008)
Solar Sensor: Service and Repair
Removal
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in an accidental airbag deployment and possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Remove the defroster grille See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Defroster
Grille/Removal.
3. Using a trim stick or another suitable wide flat-blade tool (1), gently pry between both sides of the sun sensor assembly (2) and the instrument
panel (3) to release the snap clip retainers that secure the sun sensor.
4. Disconnect the wire harness connector (1) from the sun sensor assembly (2).
5. Remove the sun sensor assembly from the instrument panel (3).
