Magnum V8-5.7L (2008)
NOTE: Before installing hub and bearing on end of axle half shaft, ensure isolation washer (1) is present on end of half shaft. Inspect washer
making sure it is not worn or damaged. Washer can be installed in either direction on shaft.
NOTE: To help upon installation, make sure that hub and bearing mounting bolts (1) extend through knuckle (3) and parking brake adapter
(2) to hold adapter in place during hub and bearing installation.
1. Position hub and bearing mounting bolts (1) though rear of knuckle (3) and parking brake adapter (2) just enough to hold adapter in place.
NOTE: Hub and bearing mounting bolt holes are not evenly spaced. Upper mounting holes (2) are not as far apart as lower mounting holes (1).
Make note of this before installing hub and bearing.
