Magnum V8-5.7L (2008)
Fuel Rail: Service and Repair
Fuel Rail - Removal
5.7L
WARNING: The fuel system is under constant pressure even with engine off. Before servicing fuel rail, fuel system pressure must be released.
1. Disconnect electrical connectors at all 8 fuel injectors. Push red colored slider away from injector (1). While pushing slider, depress tab (2) and
remove connector (3) from injector. The factory fuel injection wiring harness is numerically tagged (INJ 1, INJ 2, etc.) for injector position
identification. If harness is not tagged, note wiring location before removal.
2. Disconnect electrical connectors at all throttle body sensors.
3. Remove four fuel rail mounting bolts (1) and holddown clamps.
4. Gently rock and pull left side of fuel rail until fuel injectors just start to clear machined holes in intake manifold. Gently rock and pull right side
of rail until injectors just start to clear intake manifold head holes. Repeat this procedure (left/right) until all injectors have cleared machined holes.
5. Remove fuel rail (with injectors attached) from engine.
6. If fuel injectors are to be removed, See: Fuel Injector/Service and Repair/Fuel Injector - Removal.
