Magnum V8-5.7L (2008)
Steering Mounted Controls Communication Module: Service and Repair
Disassembly
DISASSEMBLY
WARNING: To service any component of the SCCM, the entire assembly must be removed from the column. This must be done due to the
clockspring passing through the assembly and into the self docking connector. Failure to remove the assembly could damage the pins of the
clockspring and prevent the airbag system from operating properly.
1. Loosen the three clockspring screws (1) just far enough to release the clockspring from the SCCM. Leave them in the clockspring so it won't
unwind.
2. Carefully pull straight up on clockspring to remove.
NOTE: After the clockspring is removed, there is only one more screw on the top side of the SCCM that needs to be removed and is
located at approximately the six o'clock position on the SCCM. It holds the lower side of the steering angle sensor, the lower side of the
electric tilt lever assembly, or the strengthening strut if not equipped with electric tilt.
