Magnum V8-5.7L (2008)
6. Using a suitable jumper wire, connect the voltmeter to measure between the battery positive cable terminal clamp and the starter solenoid B(+)
terminal stud. Rotate and hold the ignition switch in the Start position. Observe the voltmeter. If the reading is above 0.2 volt, clean and tighten the
battery positive cable eyelet terminal connection at the starter solenoid B(+) terminal stud. Repeat the test. If the reading is still above 0.2 volt,
perform STEP 7 and STEP 8.
7. Remove the right front wheelhouse splash shield to gain access to the battery positive cable bulkhead outside terminal, See: Body and
Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Removal. Connect the voltmeter to measure between the battery positive cable
bulkhead outside terminal and the starter solenoid B(+) terminal stud. Rotate and hold the ignition switch in the Start position. Observe the
voltmeter. If the reading is above 0.2 volt, clean and tighten the battery positive cable bulkhead outside terminal connection. Repeat the test. If the
reading is still above 0.2 volt, replace the battery front positive cable, See: Service and Repair/Battery Cables - Removal.
