Magnum V8-5.7L (2008)
19. If hub and bearing needs to be removed, perform the following:
a. Remove dust cap (2). When doing this, avoid damaging internal bore of hub to preserve seal integrity.
b. Remove hub nut (1).
c. Slide hub and bearing off knuckle spindle.
20. If shield needs to be removed from knuckle, remove 3 mounting screws, then shield.
21. If lower control arm ball joint needs to be removed from knuckle, See: Overhaul/Disassembly - Ball Joint - RWD.
AWD
INSTALLATION
1. If hub and bearing and dust shield needs to be installed on knuckle, perform following:
a. Slide shield onto rear of hub and bearing.
b. Slide hub and bearing into knuckle, lining up mounting holes in hub and bearing with those in shield and knuckle
c. Install four bolts (3) fastening hub and bearing in place. Tighten mounting bolts to 68 Nm (50 ft. lbs.).
