Magnum V8-5.7L (2008)
Steering Gear: Service and Repair
Steering Gear - Installation
All-Wheel-Drive
ALL-WHEEL-DRIVE
1. If necessary, install outer tie rods from original gear to replacement inner tie rods. Install each outer tie rod same amount of threads as it was
installed on original gear. This will get toe setting close, saving some time when toe is set later in this procedure.
2. Lift steering gear (1) into mounted position and install steering gear lower mounting bolts (2 and 3). Install upper mounting bolt (4) and nut.
Tighten all bolts to 102 Nm (75 ft. lbs.).
3. Install heat shield (3) above each inner tie rod bellows (2). Tighten screws to 10 Nm (89 in. lbs.).
