Magnum V8-5.7L (2008)
7. Install spring link-to-knuckle bolt (2) front-to-rear through knuckle and link, then install nut. While holding bolt head stationary, tighten nut to 138
Nm (102 ft. lbs.) torque.
8. Export Only - If servicing right spring link, connect headlamp leveling sensor (1) link at spring link (3).
9. Install rear spring as well as all components necessary to access it. See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Spring -
Installation
10. Lower vehicle.
11. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolt.
12. Tighten spring link bolt at crossmember to 108 Nm (80 ft. lbs.) torque.
13. Perform wheel alignment. See: Alignment/Service and Repair
Spring Link - SRT8
SPRING LINK - SRT8