Magnum V8-5.7L (2008)
Front Cross-Member: Service and Repair
Installation
INSTALLATION
NOTE: Although AWD and RWD upper control arms are similar in appearance, they are not interchangeable.
1. Install control arms. See: Control Arm/Service and Repair/Front Lower Control Arm - Installation
2. To aid installation, raise engine cradle to marked location.
3. Install four engine cradle bolts (4) and raise cradle. Tighten cradle bolts to 185 Nm (136 ft. lbs.).
4. Install stabilizer with isolators and retainers onto cradle. See: Stabilizer Bar/Service and Repair/Front Stabilizer Bar - Installation
5. On each side of vehicle, install bolts (2) fastening stabilizer bar isolator retainer (3) in place. Tighten bolts to 60 Nm (44 ft. lbs.).
