Magnum V8-5.7L (2008)
47. Route front parking brake cable with equalizer above rear crossmember.
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake
components.
48. Connect left rear parking brake cable (1) to equalizer (2).
49. Connect right rear parking brake cable (4) to connector (3) already attached to front parking brake cable (5).
50. Install J-nut for mounting parking brake cable routing bracket to crossmember.
51. Insert front parking brake cable routing bracket locating pin into front flange of crossmember (3), then install screw (2) fastening cable (1) routing
bracket to rear crossmember.
52. On each side of vehicle, slide an axle half shaft (2) through hub and bearing and install hub nut (1). Do not tighten hub nuts at this time.
53. Install rear axle differential. See: Transmission and Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Rear Axle -
