Magnum V8-5.7L (2008)
38. Insert front parking brake cable routing bracket locating pin into front flange of crossmember (3), then install screw (2) fastening cable (1) routing
bracket to rear crossmember.
39. Install rear exhaust system (2) (dual-outlet exhaust shown in figure).
40. Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.). See: Wheels and Tires/Service and
Repair/Removal and Replacement/Tires and Wheels - Installation
41. Lower vehicle until rear wheels are just above floor level.
42. Apply parking brake lever. Release lever, then reapply.
43. Check to make sure rear wheels will not rotate with lever applied.
44. Lower vehicle.
