Magnum V8-5.7L (2008)
CAUTION: It is important to tighten nut as described in following step to avoid damaging ball stud joint.
7. Place outer tie rod stud through hole in knuckle (2) and install nut (1). Tighten nut by holding stud with a wrench while turning nut with another
wrench. Tighten nut using crow foot wrench on torque wrench to 85 Nm (63 ft. lbs.).
8. Install brake rotor, then disc brake caliper and adapter assembly. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service
and Repair/Removal and Replacement/Brake Rotor - Installation
9. Install screw (3) fastening brake flex hose routing bracket (2) to knuckle (4). Tighten screw to 12 Nm (106 in. lbs.).
10. Install wheel speed sensor head (4) into knuckle and install mounting screw (3). Tighten screw to 11 Nm (95 in. lbs.).
11. Attach wheel speed sensor cable and routing clip (2) to brake flex hose routing bracket (5).
12. Install tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation. Tighten
