Magnum V8-5.7L (2008)
Rear Knuckle: Service and Repair
Rear Steering Knuckle - Installation
Knuckle
KNUCKLE
1. Install four hub mounting bolts through knuckle from inboard side allowing ends to protrude from opposite side.
2. Position knuckle on vehicle and install bolt and nut fastening camber link (1) to knuckle (4) as shown. Do not tighten bolt at this time.
3. Install bolt and nut fastening tension link (6) to knuckle (4) as shown. Do not tighten bolt at this time.
4. Install bolt and nut fastening stabilizer link to knuckle (4). Do not tighten bolt at this time.
5. Install bolt fastening toe link (3) to knuckle (4). Do not tighten bolt at this time.
6. Install bolt and nut fastening compression link (5) to knuckle (4). Do not tighten bolt at this time.
NOTE: If a new knuckle sleeve is not installed in knuckle, perform STEP 7 through STEP 11.
NOTE: Prior to using Special Tool 9361, lubricate bolt (1) threads to provide ease of use and promote tool longevity.
7. Place NEW knuckle sleeve (2) onto Installer Bolt 9361-7 (1), and slide it up to Bolt's head.
