Magnum V8-5.7L (2008)
11. Remove shock absorber (3) by tipping top outward and lifting lower end out of pocket in spring link (4).
NOTE: Do not lower repair-side of crossmember any further than necessary to gain access to link mounting bolts at crossmember.
12. Remove nut and bolt (2) mounting link to knuckle (3).
13. Remove nut and bolt (2) mounting link to crossmember (1).
14. Remove link.
Installation
INSTALLATION
NOTE: When installing link (1), ensure following to avoid mis-installation:
-
Heavier, thicker end goes toward crossmember.
-
Fore-or-aft bow faces forward (curves around coil spring).
-
Up-or-down bow faces downward.
