Magnum V8-5.7L (2008)
6. While holding stem from rotating at hex (1) or flat (2) tighten stabilizer link nuts at each end of stabilizer bar (4) to 128 Nm (95 ft. lbs.).
7. Install belly pan. See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Removal
8. Lower vehicle.
Rear-Wheel-Drive
REAR-WHEEL-DRIVE
NOTE: When attaching stabilizer link to stabilizer bar, make sure link ball joint stem is pointed inboard toward engine cradle.
1. On each side of vehicle, raise stabilizer bar (4) to stabilizer link (3) and slide link ball joint stem (1) through mounting hole in bar. Loosely install
nut (5) at this time.
CAUTION: Because of stabilizer isolator outer shape, it is very important to install isolators in position discussed in following step.