Magnum V8-5.7L (2008)
13. Clean the liftgate glass fence with an ammonia based glass cleaner and a lint-free cloth.
14. Apply pinch weld primer 15 mm (0.75 in.) wide (1) around the liftgate glass fence (2). Allow at least three minutes drying time.
15. Using a flashlight, verify that the primer is completely and evenly installed along the liftgate glass fence.
16. Re-prime any area that is not fully and evenly primed.
CAUTION: Always apply the bead of adhesive to the backlite. Always install the backlite within 5 minutes after applying the adhesive.
NOTE: If the original urethane adhesive has been exposed for more than 12 hours, the entire adhesive area will need to be re-primed prior to
installing new adhesive.
17. Apply approximately a 10 mm (0.4 in.) wide bead of adhesive (1) with a triangular nozzle triangular nozzle approximately 6 mm (0.230 in.) from
the edge of the glass (2) starting at the bottom center of the glass.
18. Run the end of the adhesive bead (1) on the liftgate glass (2) parallel to the start of the bead and smooth the ends flush.
19. Using an assistant, position the liftgate glass (2) over the liftgate glass opening and against the support spacers (1 and 3).
20. Using the grease pencil marks or tape as reference points, align the liftgate glass to the opening.
