Magnum V8-5.7L VIN 2 (2007)
Hydraulic Control Assembly - Antilock Brakes: Removal and Replacement
Removal
REMOVAL
To remove the HCU, the ICU must be removed and disassembled.
Installation
INSTALLATION
To install the HCU, assemble and install the ICU.
Removal
REMOVAL
NOTE: Refer to Warning and Cautions.
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
