Magnum V8-5.7L VIN 2 (2007)
Hydraulic System Junction Block: Service and Repair
Removal
REMOVAL
NOTE: Refer to Warnings and Caution.
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
3. Remove brake tubes (1, 2, 3 and 10) at junction block (5).
