Magnum V8-5.7L VIN 2 (2007)
Yaw Rate Sensor: Service and Repair
Installation
INSTALLATION
1. Install dynamics sensor (3) over studs mounted to floor pan tunnel (4).
2. Install mounting nuts (2). Tighten nuts to 12 Nm (110 in. lbs.) torque.
3. Connect wiring harness (1) connector to module (3).
4. Install floor console.
5. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
6. Perform Verification Test and clear any faults. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests
