dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Oil Cooler, Engine > < Engine Oil|Capacity Specifications|Page 2568
Page 1
background image

Engine Oil: Service and Repair

STANDARD PROCEDURE - ENGINE OIL SERVICE

The engine oil level indicator is located at the right hand of the engine on the 5.7L engines.

CRANKCASE OIL LEVEL INSPECTION

CAUTION:  Do not overfill crankcase with engine oil, pressure loss or oil foaming can result.

Inspect engine oil level approximately every 800 kilometers (500 miles). Unless the engine has exhibited loss of oil pressure, run the engine for about ten
minutes before checking oil level. Checking engine oil level on a cold engine is not accurate.

To ensure proper lubrication of an engine, the engine oil must be maintained at an acceptable level. The acceptable levels are indicated between the
ADD and SAFE marks on the engine oil dipstick.

1.   Position vehicle on level surface.
2.   With engine OFF, allow approximately five minutes for oil to settle to bottom of crankcase, remove engine oil dipstick.
3.   Wipe dipstick clean.
4.   Install dipstick and verify it is seated in the tube.
5.   Remove dipstick, with handle held above the tip, take oil level reading.
6.   Add oil only if level is below the ADD mark on dipstick.

ENGINE OIL CHANGE

Change engine oil at mileage and time intervals described in Maintenance Schedules.

Run engine until achieving normal operating temperature.

1.   Position the vehicle on a level surface and turn engine off.
2.   Remove oil fill cap.
3.   Hoist and support vehicle on safety stands.
4.   Remove the belly pan.
5.   Place a suitable drain pan under crankcase drain.
6.   Remove drain plug from crankcase and allow oil to drain into pan. Inspect drain plug threads for stretching or other damage. Replace drain plug if

damaged.

7.   Install drain plug in crankcase. Torque to 27 Nm ( 20 ft. lbs.).
8.   Lower vehicle and fill crankcase with specified type and amount of engine oil.
9.   Install oil fill cap.

10.   Start engine and inspect for leaks.
11.   Stop engine and inspect oil level.
12.   Install the belly pan.

NOTE: Care should be exercised when disposing used engine oil after it has been drained from a vehicle engine.

Oil Cooler, Engine > < Engine Oil|Capacity Specifications|Page 2568