Magnum V8-5.7L VIN 2 (2007)
Evaporator Temperature Sensor / Switch: Service and Repair
Removal
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or
instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the
airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system.
Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: LHD model shown. RHD model similar.
1. Disconnect and isolate the negative battery cable.
2. Remove the glove box from the instrument panel.
3. Disconnect the HVAC wire harness connector (1) from the evaporator temperature sensor (2) located on the HVAC housing (3) and remove the
sensor.