Magnum V8-5.7L VIN 2 (2007)
CAUTION: The hood release cable must be routed under the bracket assembly. Failure to route the hood release cable properly may
pinch the cable and make the hood release inoperable This may cause damage to the release mechanism and/or cable.
4. Position the hood release cable under bracket assembly.
NOTE: Make sure take rear mounting hole bosses are in headlamp bracket holes before tighten bolts. Hold bracket for sensor up tight to
headlamp bracket while tightening bolts.
5. Install mounting bolts and tighten to 9 Nm (79.5 in. lbs.). Install front bolt first then rear bolts.
6. Install air dams.
7. Connect negative battery cable.
