Magnum V8-5.7L VIN 2 (2007)
Seat Heater Switch: Service and Repair
Front Seats
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the ash receiver (1) from the instrument panel.
3. Disconnect the heated seat switch connector (2) from the heated seat switch (3).
4. From the back of the ash receiver (1), gently pry the switch (3) free and push the heated seat switch out through the front of the bezel.
Installation
INSTALLATION
1. From the front of the ash receiver (1), gently push the heated seat switch (3) in through the front of the bezel.
2. Connect the heated seat switch connector (2) onto the heated seat switch (3).
3. Install the ash receiver (1) into the instrument panel.
4. Connect the battery negative cable.
5. Verify heated seat system operation.
