Magnum V8-5.7L VIN 2 (2007)
17. Slide knuckle (3) off half shaft (1) and remove from vehicle.
18. If hub and bearing and dust shield need to be removed:
a. Remove four bolts (3) fastening hub and bearing (2) to knuckle.
b. Slide hub and bearing out of knuckle along with shield.
Installation
INSTALLATION
1. If hub and bearing and dust shield needs to be installed on knuckle, perform following:
a. Slide shield onto rear of hub and bearing.
b. Slide hub and bearing into knuckle, lining up mounting holes in hub and bearing with those in shield and knuckle