Magnum V8-5.7L VIN 2 (2007)
10. Remove screw (2) fastening front parking brake cable (1) routing bracket to rear crossmember front flange (3).
11. If equipped with standard or premium disc brakes, on each rear disc brake:
a. While holding guide pins from turning, remove disc brake caliper guide pin bolts (2).
b. Remove brake caliper (1) from brake adapter (3) and pads.
c. Guide brake caliper up through suspension, following brake hose path. Support caliper above rear suspension using with bungee cord or wire
to keep caliper from overextending brake hose when crossmember is lowered.
CAUTION: When pushing pistons back into caliper bores, use only a trim stick as shown or other suitable soft tool. Never use a screwdriver or
other metal pry bar due to potential damage to braking surface of rotor, caliper, pistons or dust boots.
12. If equipped with SRT8 disc brakes, on each rear disc brake, place trim stick (4) between brake pad (2) and outer edge of rotor (3).
13. If equipped with SRT8 disc brakes, on each rear disc brake, using trim stick, slowly apply pressure against brake pad (2) until both pistons (on that
