Magnum V8-5.7L VIN 2 (2007)
NOTE: Prior to using Special Tool 9361, lubricate bolt (1) threads to provide ease of use and promote tool longevity.
2. Place NEW knuckle sleeve (2) onto Installer Bolt 9361-7 (1), and slide it up to Bolt's head.
3. Starting from knuckle forward end, slide Bolt 9361-7 (1) with sleeve (5) through knuckle (2) and spring link ball joint (3).
4. Install thrust bearing and nut (4) on end of Bolt. When installing thrust bearing on Installer, be sure to place hardened side against nut.
Place bearing outer cage against stationary component.
5. While holding Bolt head (1) stationary, rotate Nut (4) (using hand tools) installing sleeve in knuckle. Install sleeve until Nut stops turning. Do not
overtighten Nut.
6. Remove special tool.
7. Install spring link-to-knuckle bolt (2) front-to-rear through knuckle and link, then install nut. While holding bolt head stationary, tighten nut to 138
Nm (102 ft. lbs.) torque.
