Magnum V8-5.7L VIN 2 (2007)
6. Utilizing slit, remove each isolator (1) from stabilizer bar (2).
7. On each side of vehicle, remove nut (5) fastening stabilizer link (3) to stabilizer bar (4). Slide link ball joint stem (1) from bar, then remove bar
from vehicle.
All-Wheel-Drive
ALL-WHEEL-DRIVE
1. Utilizing slit in isolator, install each stabilizer bar isolator on bar. Make sure slit in isolator is positioned toward rear of vehicle once installed on
vehicle.
2. Install stabilizer bar isolator retainer over each isolator.
NOTE: When attaching stabilizer link to stabilizer bar, make sure link ball joint stem is pointed inboard toward engine cradle.