Magnum V8-5.7L VIN 2 (2007)
1. Place shock assembly into front suspension using reverse direction in which it was removed.
CAUTION: It is important to tighten nut as described in following step to avoid damaging ball stud joint.
2. Place upper ball joint stud (1) through hole in top of knuckle and install nut (4). Tighten nut by holding ball joint stud with a hex wrench while
turning nut with a wrench. Tighten nut using crow foot wrench on torque wrench to 47 Nm + 90° turn (35 ft. lbs. + 90° turn).
3. Connect wheel speed sensor cable routing clip (2) at brake tube bracket (3).
4. Install lower shock mounting bolt (3) attaching shock assembly (1) to lower control arm (4). Do not tighten bolt at this time.
