Magnum V8-5.7L VIN 2 (2007)
10.
Install a plastic tie strap around the cable base and steering column mounting bracket as shown in Figure 6.
11.
After installing the plastic tie strap, cut off the excess end of the tie strap.
12.
Install the silencer panel into position and install the two push-in fasteners (Figure 3).
13.
Install the Energy Absorbing (EA) bracket and three mounting bolts. Tighten the bolts to 62 in. lbs (7 N.m) (Figure 2).
14.
Connect the trunk release switch and snap the knee bolster into position.
15.
Install the two knee bolster retaining screws. One screw is located in the door jam, the other screw is located on the bottom of the instrument panel
knee bolster.
16.
Install the instrument panel side trim cover at side of the instrument panel (Figure 1).
