Magnum V8-5.7L VIN H (2005)
4. Partially lower the vehicle and remove the push-pin retainers (5) (three-sedan, three-wagon, one-Charger) that secure the rear fascia assembly (6)
to the decklid sill.
5. On all models, remove the two deck lid bumper stops (1).
6. Carefully pull the rear fascia assembly rearward to disengage the two push-pin retainers (2) from the slots (3) in each side of fascia and position
the fascia to gain access to the license lamp and park assist.
7. If equipped, disconnect the park assist sensor wire harness connector (2) from the tail lamp wire harness connector (1) and remove the rear fascia
assembly (3) from the vehicle.
8. If equipped and if required, remove the park assist sensors from the rear fascia assembly..
9. If required on SRT8 models, remove the lower fascia from the rear fascia assembly and discard the metal retaining clips.
