Magnum V8-5.7L VIN H (2005)
A memory setting is recalled by pressing either the memory "1" or "2" button, or by pressing the unlock button on a "linked" Remote Keyless Entry
(RKE) transmitter.
For driver safety, memorized settings can not be recalled if the transmission is in any position other than park or the seat belt is latched.
A key FOB is linked to a memory setting by pressing the set button and then pressing either the memory "1" or "2" button within 5 seconds of
pressing the set button, then by pressing the "lock" button on the selected key FOB.
The memory system "Easy Entry and /Exit" feature provides the driver with more room to enter or exit the vehicle. When the seat is in a memorized
position, it will move rearward 55 millimeters or to the end of its travel, whichever occurs first, when the key is removed from the ignition switch lock
cylinder. This is a customer programmable feature of the overhead console. The seat will return to the memory position when the driver turns the vehicle
s ignition switch out of the LOCK position.
The memory system "Tilt in Reverse" feature tilts the outside mirrors down a fixed, incremental angle when the vehicle is shifted into REVERSE with
the ignition switch in the RUN position. This feature provides the customer with a better view of the ground and vehicle in the area of the rear tires when
backing up. The mirrors move back to their previous position when the vehicle is shifted out of REVERSE.
The memory system "learns" the seat and adjustable pedal motor maximum end positions when the motor reaches the limit of travel in any direction and
stalls. Subsequently, movement will stop just short of that position to avoid extra stress on the motors and mechanisms. If the system learned a maximum
position as a result of an obstruction, as for instance if a large object was placed on the floor behind the seat, the system can relearn the true maximum
position through manually operating the power seat after the obstruction is removed.
NOTE: It is normal for the power accessories contained in the memory system to stop at the maximum learned position and then continue to the true
maximum position when the control switch is released and then applied in the same direction a second time.
Certain functions and features of the memory system rely upon resources shared with other electronic modules in the vehicle over the Controller Area
Network (CAN) bus. The CAN bus allows the sharing of sensor information. This helps to reduce wire harness complexity, internal controller hardware,
and component sensor current loads. At the same time, this system provides increased reliability, enhanced diagnostics, and allows the addition of many
new feature capabilities. For diagnosis of these electronic modules or of the CAN bus, the use of a scan tool and the proper diagnostic information are
needed.
