Magnum V8-5.7L VIN H (2005)
Sunroof / Moonroof Module: All Technical Service Bulletins
Body - Rear of Sunroof Not Flush With Roof
NUMBER: 23-028-05 REV. A
GROUP: Body
DATE: August 27, 2005
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 23-028-05, DATED
MAY 5, 2005, WHICH SHOULD BE REMOVED FROM YOUR FILES. ALL REVISIONS
ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDES REVISIONS TO THE
DIAGNOSIS.
THE StarSCAN FLASH FILES FOR THIS BULLETIN ARE AVAILABLE VIA THE
INTERNET.
THE FLASH FILE WILL BE AVAILABLE ON THE NEXT StarSCAN® UPDATE CD
RECEIVED AFTER CD 6.02.
SUBJECT:
Rear Of Sunroof Glass Is Not Flush To Roof
OVERVIEW:
This bulletin involves flash reprogramming the sunroof motor and possibly replacing the sunroof drain channel.
MODELS:
2005 (LX) 300/Magnum
NOTE:
This bulletin applies to vehicles built prior to September 1, 2004 (MDH 0901XX) and equipped with a Sunroof (sales code GWA).
SYMPTOM/CONDITION:
Sunroof does not fully close (fit flush to roof) and/or fully vent and/or is noisy at the end of full open travel.
DIAGNOSIS:
1.
Verify the rear of the sunroof glass to roof flushness concern.
2.
**UNCALIBRATE THE SUNROOF.
a.
Insure the battery is at least 12 Volts.
b.
Place the ignition switch in RUN position.
c.
Locate the sunroof fuse (Fuse 44 in the Power Distribution Center located in the trunk).
d.
While the sunroof is still in motion, have an assistant remove the sunroof fuse.
e.
Reinstall the sunroof fuse.
3.
RECALIBRATE THE SUNROOF
a.
Press and hold the sunroof vent switch until it stops at the full vent position.
b.
Verify sunroof operation by opening, closing, and venting the sunroof.
c.
If the uncalibrate/recalibrate procedure corrected the sunroof glass to roof fit, perform the Repair Procedure.
4.
If the uncalibrate/recalibrate procedure did not eliminate the sunroof glass to roof fit, use the procedures outlined in TechCONNECT(R)
BODY/SUNROOF/GLASS PANEL/ADJUSTMENTS to adjust the glass panel. If the sunroof glass is now flush, perform the Repair Procedure.**
