Magnum V8-5.7L VIN H (2005)
1. Completely retract caliper piston back into bore of caliper. Use hand pressure or a C-clamp may be used to retract piston, first placing a wood
block over piston before installing C-clamp to avoid damaging piston.
CAUTION: Use care when installing caliper onto disc brake adapter to avoid damaging boots on caliper guide pins.
2. Push caliper guide pins into caliper adapter to clear caliper mounting bosses when installing.
3. Slide caliper over brake pads and onto caliper adapter (3).
CAUTION: Extreme caution should be taken not to crossthread caliper guide pin bolts (2) when they are installed.
4. Align caliper mounting holes with guide pins, then install guide pin bolts (2). While holding guide pins from turning, tighten bolts to 60 Nm (44 ft.
lbs.) torque.
5. Install banjo bolt (6) attaching brake hose (1) to caliper (5). Install NEW washers (7) on each side of hose fitting as banjo bolt is placed through
fitting. Thread banjo bolt into caliper and tighten to 43 Nm (32 ft. lbs.) torque.