Magnum V8-5.7L VIN H (2005)
If caliper fails inspection, disassemble and recondition caliper, replacing the seals and dust boots or replace caliper.
ASSEMBLY
CAUTION: Dirt, oil, and solvents can damage caliper seals. Ensure assembly area is clean and dry.
NOTE: Always use new, clean Mopar(R) DOT 3 Motor Vehicle Brake Fluid or equivalent when assembling brake caliper.
NOTE: Never use used or old piston seals or boots for reassembly.
1. Lubricate caliper piston, piston seal (1) and piston bore (2) with clean, fresh brake fluid.
2. Install NEW piston seal (1) in groove of caliper bore (2). Seal should be started at one area of groove and gently worked around and into the
groove using only your clean fingers to seat it.
3. Install NEW dust boot (1) on piston (2) and work boot lip into groove at top of piston. Stretch boot downward, straightening boot folds, then move
boot back upward as necessary until folds snap uniformly into place.
