Magnum V8-5.7L VIN H (2005)
1. Install parking brake lever (3) over mounting studs (1).
2. Install bolt (4) and two nuts (2) mounting parking brake lever to body (5). Tighten bolt and nuts to 26 Nm (19 ft. lbs.) torque.
3. Connect wiring connector (7) at parking brake switch (1).
4. Guide cable end (3) up through lever bracket and press cable housing retainer (7) into bracket allowing retainer fingers to lock cable in place.
5. Connect front parking brake cable strand (3) at lever connector (2).
6. If installing new lever, remove pin locking out automatic tensioning spring.
