Magnum V8-5.7L VIN H (2005)
4.
Loosen the upper fill tube attaching bolt.
5.
Verify that the transmission fill tube is centered (no side loading) in the transmission housing opening and seal.
6.
Tighten the upper attaching bolt to 40.7 Nm (30 ft. lbs.). The upper bolt MUST be tighten before the lower bolt is tightened.
7.
Tighten the lower fill tube attaching bolt to 11.9 Nm (105 in. lbs.).
8.
Thoroughly clean the base of the fill tube and the area of the transmission where the fill tube mates to the transmission housing.
9.
Apply ATF-RTV sealer, p/n 05010884AA, to the area where the fill tube mates to the transmission housing.
NOTE:
Verify that the RTV sealer is installed completely around the base of the fill tube and completely seals off the transmission housing fill tube seal from
possible water intrusion past the seal.
10.
Remove the transmission oil pan. Drain the transmission fluid.
11.
Thoroughly clean the transmission oil pan.
12.
Install the transmission oil pan. The pan gasket is reusable.
13.
Lower the vehicle leaving the rear wheels off the ground.
14.
Fill the transmission with four (4) quarts of ATF+4 transmission oil.
15.
Apply the service brake and start the vehicle engine.
16.
Shift the transmission into drive, release the service brake, and lightly accelerate the engine speed to allow the transmission to upshift through all
forward gears.
17.
Apply the service brake and stop the wheels from turning.
18.
Shift the transmission into reverse and release the service brake. Let the wheels turn for approximately 5 seconds.
19.
Apply the service brake and stop the wheels from turning.
20.
Repeat steps 16 - 19 two more times.
NOTE:
At times, the transmission may go into "limp-in" mode due a to transmission generated DTC. The DTC must be erased/cleared before proceeding
further. The transmission fluid may not be properly circulated in the transmission if the transmission remains in "limp-in" mode.
21.
Stop the engine and place the transmission in the PARK "P" position.
22.
Raise the vehicle.
23.
Remove the transmission oil pan. Drain the transmission fluid.
24.
Thoroughly clean the transmission oil pan.
25.
Install the transmission oil pan. The pan gasket is reusable.
26.
Lower the vehicle leaving the rear wheels off the ground.
27.
Fill the transmission with four (4) quarts of ATF+4 transmission oil.
28.
Apply the service brake and start the vehicle engine.
29.
Shift the transmission into drive, release the service brake, and lightly accelerate the engine speed to allow the transmission to upshift through all
forward gears.
30.
Apply the service brake and stop the wheels from turning.
31.
Shift the transmission into reverse and release the service brake. Let the wheels turn for approximately 5 seconds.
