Magnum V8-5.7L VIN H (2005)
PARTS REQUIRED:
SPECIAL TOOLS/EQUIPMENT REQUIRED:
**REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:
NOTE:
The StarSCAN(R) diagnostic scan tool fully supports Internet connectivity. However, in order to take advantage of this feature you must first
configure the StarSCAN(R) for your dealership's network. For instruction on setting up your StarSCAN(R) for the dealer's network; refer to the
StarSCAN(R) Quick Start Networking Guide available on DealerCONNECT > Service > StarSCAN and StarMOBILE Tools > Online
Documentation or at website under the "download center".
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1.
Open the hood, install a battery charger and verify that the charging rate provides approximately 13.5 volts. Set the battery charger timer to
maintain the charging voltage for the duration of the flash process.
2.
Connect the CH9410 StarSCAN(R) ethernet cable to the StarSCAN(R) and the dealer's network drop.
3.
Connect the CH9404 StarSCAN(R) vehicle cable to the StarSCAN(R) and the vehicle.
4.
Power ON the StarSCAN(R).
5.
Retrieve the old ECU part number. Using the StarSCAN(R) at the "Home" screen:
