Magnum V8-5.7L VIN H (2005)
1.
For vehicles equipped with Express Window (Sales Code JP3), calibrate the windows as follows:
NOTE:
Vehicles equipped with Express Windows will have BOTH front window switches labeled "AUTO".
a.
Turn the ignition key to the "RUN" position.
b.
Move the driver's window upward until the window stalls in the full up position. Allow the window motor to stall for at least two (2) seconds
before releasing the switch.
c.
Move the driver's window downward until the window stalls in the full down position. Allow the window motor to stall for at least two (2)
seconds before releasing the switch.
d.
Move the driver's window upward until the window stalls in the full up position. Allow the window motor to stall for at least two (2) seconds
before releasing the switch.
e.
Repeat Steps b. - d. for the passenger side window.
f.
Verify that the windows learned the calibration by operating the express up and express down features on the windows.
2.
For vehicles equipped with the Electronic Stability Program (ESP) (Sales Code BNB), calibrate the Steering Angle Sensor as follows:
NOTE:
Vehicles equipped with ESP Will have an ESP ON/OFF switch present in the instrument panel center stack.
a.
Start the engine and let it idle.
b.
Turn the steering wheel to the right until the wheel is locked at the full right position.
c.
Turn the steering wheel to the left until the wheel is locked at the full left position.
d.
Turn the steering wheel until the wheels are centered.
3.
Cycle the ignition switch to the "OFF" position and then back to the "RUN" position.
4.
Use the StarSCAN to clear any DTC's from all modules.
