Magnum V8-5.7L VIN H (2005)
14. Insert end of cable (1) through rear knuckle (3) and install mounting screw (2). Tighten screw to 8 Nm (71 inch lbs.) torque.
15. Install parking brake shoe support over hub and bearing mounting screws and onto face of knuckle.
16. Install shoe actuator lever (1) on end of parking brake cable (2). Make sure actuator lever is positioned with word "UP" facing outward.
17. Install parking brake shoes as well as all components necessary to access them.
NOTE: Before installing hub and bearing on end of axle half shaft, ensure isolation washer is present on end of half shaft. Inspect washer making sure
it is not worn or damaged. Washer can be installed in either direction on shaft.
18. Install hub and bearing as well as all components necessary to access it.
